more questions

[steamer]

Marv...relax

Honey vs vinegar...heh?

[Pete49]

Marv I did read the intro ....I tend to do that.... but I may have read it in a way I thought it was not as it was written.
I sometimes do that probably from years of scan reading. I will now go back and read it again severely chastised. I'm glad you had your coffee as I would probably still be hiding in fear if you had not. (no emoticons so as to not further upset you mood)
Pete
PS I fibbed

[mklotz]

Marv...relax

Honey vs vinegar...heh?

The honey is in the Introduction.

[steamer]

 

OK bud!

Dave

[Mosey]

With the greatest of cordial respect - you guys are not seriously suggesting he cut a 64t module .5 gear using choral layout are you???

I'm not suggesting anything, Tel; just correcting the math and English.  BTW, is a "choral layout" a bunch of prostrate singers?

Marv,
Did you mean "prostate" singers?
Mosey

[mklotz]

No, but guessing from your age (two years older than I), that would understandably be in the forefront of your mind.

[Mosey]

Just imagine the advanced wisdom accruing from those 2 years!
And, its not in the front.
Mosey

[mklotz]

I'm imagining as hard as I can but, so far, bupkis.

[tel]

Where did I go wrong? I try to lead a good life, don't even pull the wings off flies, but .....

[Pete49]

Just an update to show I haven't jumped ship. I started on a gear yesterday (pics of arbor in the phone as we speak) and it went west.... not a good thing and after some checking I find my dividing head is the problem. The brass bushes are bigger than the shaft by a very little bit .002ish and also not inline    so at one point it cut deeper than needed and the gear blank was history. Oh well onwards and upwards and I will make another shaft with more precision after I bore the bushes so they are inline and square to the bore.
Pete
editted to add pics