* Come and see ModelEngineMaker.com at the Midlands Model Engineering Exhibition 2026!

« previous next »
Pages: [1]   Go Down

Author Topic: Cylinder Hone  (Read 411 times)

Offline Art K

  • Full Member
  • ****
  • Posts: 1897
  • Madison, Wisconsin USA
Cylinder Hone
« on: September 15, 2026, 03:18:51 am »
I thought there was an article about making a cylinder hone out of brass. When I searched I found, p hone, hone y, p hone y, ect. ad nauseum. Anyone know where the article is?
Art
Logged
"The beautiful thing about learning is that no one can take it away from you" B.B. King

Offline Roger B

  • Global Moderator
  • Full Member
  • *****
  • Posts: 7124
  • Switzerland
Re: Cylinder Hone
« Reply #1 on: September 15, 2026, 06:52:04 am »
Logged
Best regards

Roger

Offline Art K

  • Full Member
  • ****
  • Posts: 1897
  • Madison, Wisconsin USA
Re: Cylinder Hone
« Reply #2 on: September 17, 2026, 02:43:07 pm »
Roger,
In my mind I was seeing something different, that looks very elegant though. We had the right sized flex hone which cleaned up the cylinder and gave the appropriate cross hatch.
Art
Logged
"The beautiful thing about learning is that no one can take it away from you" B.B. King
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.5 © 2008-2012, SimplePortal