Engines > Your Own Design

Sticking Engine M2

<< < (2/9) > >>

hammer:
Thank you I need a little encouragement. Below the state of play. Geoff

Stilldrillin:
Watching quietly, Geoff........

Looking good so far!  :ThumbsUp:

David D

Don1966:
That's very interesting Geoff, a cylinder on each side. The gear is what I don't quite understand. Are you powering the gear with the cylinder?

Don

hammer:
Thats right don, the cylinder of brass will become the crank arms. Seperated from the engine, to the left. The large gear in first photo will be fixed to the paddle shaft. The ideal ratio is 3to1 reduction, the gears from my scrap box are a little less. Geoff

hammer:
Crank completed. Note the arm reduced on the inside so the bearing can be incresed.  Only 3/32" but every little helps. Geoff

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version