Engines > Your Own Design
Twin Rotary Valve Engine
Sanjay F:
Looking good, steady progress :popcorn: :ThumbsUp:
PaulR:
--- Quote from: Sanjay F on July 11, 2026, 05:04:22 pm ---Looking good, steady progress :popcorn: :ThumbsUp:
--- End quote ---
Cheers! Got the other end soldered up and all seems ok. Turns out my 'brass' towel rail is plated copper! No matter, it does the job.
PaulR:
Not much time to devote to the workshop lately but managed to get the base plate to size, cut-outs filed and the assembly fixed to it.
PaulR:
Only to find that I made a booboo and need to make the cut-outs for the cranks deeper - more filing in my next workshop visit!
Jeff123:
Hi Paul
Just read through the entire, very interesting, as ever in your case.
Your drawing shows the crank pins set at 180 degrees. Is that just for convenience, making the drawing easier or are you intending to set them at 90 degrees.
Just curious, like I say interesting stuff :Doh:
Geoff
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version