Engines > From Plans

A vertical steam pump.

<< < (2/15) > >>

Michael S.:
Next up is the base plate, made from 8 mm sheet steel with four mounting holes. Small raised sections are added around the four holes to give it a cast-metal appearance.
The crankshaft requires a bearing bushing; a 15 mm steel tube was fabricated and joined using silver solder.
After that, a cutout needs to be machined to accommodate the eccentric.

Regards, Michael

Sanjay F:

--- Quote from: Michael S. on June 19, 2026, 09:03:18 am ---Thanks, everyone.

Jason, I’m actually familiar with this design from fire engine steam engines; I’ve often seen this type of slotted crosshead there.
The drawing and construction instructions come from the Dutch book *Handbuch Modelldampfmaschinen* (Model Steam Engine Handbook).
It’s a good book—especially for beginners.

Michael

--- End quote ---

The engine on the front cover does not look like a beginners engine, if it is, I must be way underqualified to call myself a beginner!  :Lol:

Michael S.:
The stand still requires a top and a bottom plate—one to serve as the base and the other at the top for the cylinder.
The parts are attached with screws and then soldered using soft solder.
The large base plate was also stamped on the underside so that people will know later who built it and when.

Michael

Michael S.:
Hi Sanjay, the book does include simple construction plans, and it explains a great deal about steam engine valve gear, boiler construction, locomotives, portable engines, steamrollers, and workshop techniques.

Michael S.:
The flywheel was turned from a 70 mm piece of steel. For the bearing bushings, I am using off-the-shelf bronze ones; three of them fit into the bearing sleeve. Only the outer diameter needs to be reduced slightly. The bronze bearings are simply press-fitted in. And finally, there is the crank disc; it, too, is simply press-fitted onto the 8 mm crankshaft.

Michael

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version