Engines > Restoration of Model Engines

Project Vulcan

<< < (2/16) > >>

Jasonb:
3 bearings would be quite rare. Usually two with one being immediately behind the crank arm/disc. Then you would have the eccentric(s) and flywheel and finally the outrigger bearing. Pulleys could go outside the outrigger or between the two.

Just moving uour outer bearing would leave a lot of redundant casting on that side of the engine. I would be inclined to go for a narrower base more along the lines of a Stuart victoria or Beam but not that tall outrigger support they use. Easy enough to either sandwich a couple of thicknesses of plate together or mill a rebate around a thicker piece and then bond on a few bosse sfor hold down bolts, etc

Jasonb:
Something like this. Probably needs a cut out to clear the crank arm and a raised boss if you are fitting the pump. Fairly simple piece of 1/4 or 6mm plate with a larger 1/8" or 3mm one below. The pads from the same thickness material as are the D shaped hold down bosses. Or mill from 1/2" or 12mm aluminium and just add the hold down bosses.

Looking at the Westbury article he did not show a bed casting so it is possible the one that Reeves now do which is the same as yours had the pattern made by someone else. that may explain why it is not really upto the detail of the rest of the engine.

Sanjay F:
I'm looking your drawings and thinking I have all the measurements and boss heights from the current base and could just get it 3d printed including the outrigger piece to look the same? :D If I used Aluminium how to I attach the D-shaped bosses? A lot to think about!

I found this, clearly someone has put some effort into creating the CAD and animating it:

http://www.youtube.com/watch?v=KKdjQdDY7iU

The actual movement of the engine and parallel motion mechanism seems very smooth when turned by hand:

http://www.youtube.com/watch?v=wsPddgFK_tY

Jasonb:
Bosses can be stuck on with JB Weld. I would probably drill the bosses first, bond on and then finish the holes right through.

It starts to get into the size they say distortion may be possible so if 3D printing add a bit of height to allow for skimming the top raise dpads level and also flating the bottom.

3D printing will be about £150 or you could buy a bit of aluminium flat bar for £15. Add in a couple of nice sharp ali specific cutters and a tube of JBWeld and you would still have change from £30. Sandwich of 1/8, 1/4 and 1/8 would be about the same for metal and JBW.

Chipswitheverything:
This model is a good candidate for a restoration - an attractive engine and prototype  essentially, but not any sort of historic artifact that needs debate over whether it should be largely left in original condition.
I'd go with the thought about having an outrigger bearing , and the flywheel partly inserted into the base arrangement, ( as I decided to do with my Major Beam build which you have checked out a while back ), I think it makes a pleasing balance of engine and base.
The slimline base design that Jason has indicated would look very nice. Dave

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version