Engines > Restoration of Model Engines

Rebuilding my Upshur vertical single

<< < (2/4) > >>

awake:
Art, I am just beginning to learn, with the hope of making an IC engine in the next year or so. That to say that I hope my question is not hopelessly ignorant or muddled by using the wrong terms ... !

Is the aluminum rod running directly on the crankpin? I think that is what I am seeing / understanding. What about the small end of the rod - is that also aluminum running on steel, or is there any bearing material (bronze?) there?

Also, how has the big end of the rod been lubricated?

Again, I hope I'm not out of line (or out in left field) by asking - just eager to learn ...  :cartwheel:

Dave Otto:
Wow that is some pretty serious wear!
I would think that 7075 might be a good choice but someone with more experience in this area may have a different idea.

Dave

cheepo45:
Wow! That rod is worn!
That must have sounded interesting at 7000+ RPM!
 Scott

Art K:
Awake,
No you aren't in left field. It was designed to run aluminum on steel, apparently it has fairly good lubricant qualities as a bearing. There is a center drill hole at the end of the cap which lubes the crank. Any question is a good? I think bronze would wear better but be more of a PITA to make.
Dave,
I will have to see if I have any. I have lots of aluminum that isn't labeled.
Art

Art K:
Also I might add It was originally designed with less cooling. I modified that when I was told it would idle all day but overheated when the RPM was higher. I did at one point in time run it at about 6000RPM for 20 minutes and melted the Perry carb I was using, it didn't ever stall from overheating. I must admit in the last few years it hasn't run very well, now I know why.
Art

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version