Engines > From Kits/Castings
B.Hick & Son oscillating engine
Jasonb:
Holding by the inside of the rim or mounted on a faceplate should help reduce those chatter marks you are getting. Of the 100 or so flywheel castings I have machined maybe only one was held by the hub due to rim profile and spoke placement.
PaulR:
--- Quote from: Jasonb on May 18, 2026, 08:39:35 pm ---Holding by the inside of the rim or mounted on a faceplate should help reduce those chatter marks you are getting.
--- End quote ---
I bet that would stop the noise as well. I've had the same problem when machining solid flywheels even in the 2" range when mounted on a stub mandrel - I guess putting a large 'washer' packing piece slightly smaller than the OD between the chuck jaws and the work piece might help when a faceplate can't be used.
Sorry to hijack the thread Sanjay! I'm sure the f/w will be fine after some polishing, finders crossed the other parts are better.
Sanjay F:
No problem Paul.
I've not had issues with flywheels since my early days, this one is particularly gritty and probably making it the way I have has exacerbated the problem. It'll be fine, if you look this the 'new' replacement flywheel and its still fairly porous along the spokes! ::)
So inside jaws and machine outer rim, face edge, centre boss and drill/ream centre in one go, then flip over and face the other edges still held by the rim? If using a f/plate I guess you have to find the best position of the outer edge by dialing in. I'm always worried I wont find the same position when I flip it over?
Jasonb:
Set the flywheel to run as best as possible to the inside edge of the rim as you won't be turning that. This applies to a chuck as well as a faceplate.
When you flip the flywheel over you don't really need it perfectly concentric as you are only making facing cuts. If you do need to clock it in then a dti on the machined face and a few gentle taps will do it if you just nip up the clamping screws.
As for polishing the rim, I would think this engine originally ran a separate belt pully so the flywheel would have been completely painted
Sanjay F:
Square holes???? Are they really necessary? Seems like a lot of faff for what return? I've looked at Jo's build (see last pic) and it appears she thought the same .............
Maybe a hole which is 3/32" or 8BA clear will be suitable?
EDIT: actually looks bigger maybe 5BA?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version