Supporting > My Workshop

dremel bit holders

<< < (2/2)

mklotz:
My approach was a quick and dirty fix. Six 3 x 1" pieces of corrugated cardboard were cut. Five were glued face-to-face and the sixth was glued on the bottom to close off the corrugations of the other five. As can be seen from the photo, this allows very high packing density; I didn't have the patience to count but there's got to be 60+ bits in roughly six cubic inches of space.

PROS:

Quick to make
High density
No hole layout or drilling required
Accepts both shank sizes
Easily expandable
Zero cost


CONS:

Less rugged than wood
May require the use of tweezers to extract some burrs
Unsightly

I'm pleased with the practicality of the solution but my sense of tool artistry is still annoyed.

Navigation

[0] Message Index

[*] Previous page