Supporting > Tooling & Machines
How to use a flycutter??
Charles Lamont:
You would use your bench grinder. It does not matter that it will produce a slightly concave face. You should read up about cutting tool angles. First you need clearance angles away from the tip. These want to be about 8 or 10 degrees, whatever the metal (more for plastic). Next are rake angles. These are the angle(s) that the cutting surface slopes away from the tip. They depend on the material and are a matter of debate. Typical values are 0° for brass and cast iron, 10° for mild steel, and 20° for aluminium. In practice, you can usually use about 10° for most jobs. For tip radius, I would start with something like 1 mm.
It helps a great deal if your bench grinder has work rests that are better than the frequently seen bits of bent tin, and it is particularly useful if they can be tilted away from the wheel to provide the cutting angles.
If you want to be fussy, you would finish the tip radius and edge with a hand held hone. Start with a grey corundum one, half-inch square and preferably 6 inches long (4 would do at a pinch). The concave surface left by the grinder helps with this as the central part can be left as ground.
This diagram may help.
Also a visit to the TEE stand at MMEX for Workshop Practice series books.
Sanjay F:
Firstly I'm glad I trammed the mill - it was out!
I'm being a dumbass, first of all which way up should the tool bit be, like in the first pair or second pair of photos? Secondly can someone sketch the angles onto the tool tip on whichever is the correct photo please; I'm struggling to understand the diagrams and I've even watched a video ............thank you!
Jasonb:
If you have a bench sander/liisher that will also do the "grinding" it's what I used for that one in the photo which is only a cheap Clarke job.
You can always sitck a left hand insert turning tool in the flycutter ;)
Yes diameter is the circle that the cutting edge is rotating at.
Did you open my pdf with teh drawing and stage sof how to grind a flycutter?, it's a bit hidden above the photo.
Jasonb:
.
Sanjay F:
Yes, I did open your diagram and still struggled to orientate the tool bit the correct way round and work out which angle was what! ::)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version