Supporting > My Workshop

Oliver's New Home

(1/2) > >>

sshire:
My lathe is semi-of-out-of-commission until the new power supply for the carriage feed motor arrives on Tuesday.
This seemed like a good time to put the "new" Oliver S-4 Die Filer in a proper environment.
The stand (until this morning) held a Delta Thickness Planer for wood. It will probably go to the next Cabin Fever auction.
The switch was from Amazon. The Oliver never had a switch. I guess the first shift plugged them in and 8 hours later unplugged them.
PVC pipe from a friend's swimming pool extras when they installed the heater.
The magnifying lamp has been around the shop forever.
I'm going to put a small partition between the Oliver and the red blast cabinet behind it. I have the cabinet well sealed and really get no glass beads trying to escape, but I'm just protecting Oliver.

steamer:
I like it Stan!     :ThumbsUp:

Dave

Jo:
I think I could find a use for that   :naughty: Its looking good ;)

Jo

sshire:
Jo
I'd loan it to your for your turning demo but I fear the shipping would be a bit out of hand :Lol:

b.lindsey:
That looks great Stan. As to the bead blasting cabinet, i have one identical except for color...have you had any issues with the filter clogging up? I have removed it , shaken it, reverse blown it out and it still restricts air flow to the point that the sealed lid pressurizes and performance falls off sharply. Any suggestions?

Bill

Navigation

[0] Message Index

[#] Next page