Author Topic: Lockdown Hit-and-Miss Engine from bar stock  (Read 2837 times)

Offline Roger B

  • Global Moderator
  • Full Member
  • *****
  • Posts: 5436
  • Switzerland
Re: Lockdown Hit-and-Miss Engine from bar stock
« Reply #15 on: September 27, 2020, 02:07:27 PM »
Very nicely done  :praise2:  :praise2:  :wine1:

Do you have any thoughts for your next project?
Best regards

Roger

Offline Misterg

  • Full Member
  • ****
  • Posts: 18
Re: Lockdown Hit-and-Miss Engine from bar stock
« Reply #16 on: September 27, 2020, 10:18:09 PM »
Do you have any thoughts for your next project?

Thank you very much, Roger  :cheers:

I have a few things on my list that I'd like to make - a vacuum / flame eater engine, a low temperature Stirling, a marble Stirling, and a parallel twin of some sort with a side cam shaft driven by skew gears (I'm awed by the Ruston & Hornsby twins), but I'm not sure which will be next. I have a long term ambition to make a 1 cylinder long slice of a Deltic type engine (probably spark ignition, rather than diesel though), but that is very much pie in the sky at the moment!

Offline scc

  • Full Member
  • ****
  • Posts: 1047
  • Lancashire, UK
Re: Lockdown Hit-and-Miss Engine from bar stock
« Reply #17 on: September 28, 2020, 05:23:36 PM »
A lovely engine, well made and beautifuly finished, and a cracking runner as well :praise2:    I fully agree with "using what you've got"  and keeping things in house.    Well Done :cheers:        Terry