Welcome to ModelEngineMaker !If you have problems registering or logging in, please use the contact menu option to request assistance.
Next move on the uprights is to bend them. I have never had to bend cold rolled ms before only black hot rolled. Now then, do I need to use heat?
I'm using 3/16" plate which has had 2hours in t'oven at 220 before I started.
It's not that hard to bend steel, there was a question on ME about bending some 3/4 x 1/8 at 20ishdeg
Jason, Just noticed the locating tabs on the Tidman...Nice. Terry