Help! > Mistakes, muckups, and dangerous behaviour
help with silver solder
cmitcham:
the flux in the picture is harris sta silv black. i will admit the solder is from ebay a couple years ago, so i don't remember which silver content. i did use it sucessfully with harris white flux when i got it, but that was stainless parts with very little mass. since the current parts are beefier, i guessed i would be heating longer so went with the black.
i did play with some scrap today, and found that the "crispy black mess" is simply the flux after the water is gone. i continue adding heat, and it melts back to a liquid, cleans the joint,and then solder starts to flow. excited with my breakthrough, i fluxed up my crankcase again for anothe try, but before the flux was ready, my propane tank died :(
thanks for the quick replies, i'll continue this thread after this week's vacation.
crueby:
Great! Sounds like you are back in business, once Murphy's Law leaves your propane tank alone!
tghs:
replace propane rig with mapp...
Navigation
[0] Message Index
[*] Previous page
Go to full version