Hi everyone
Since I always enjoy watching buildlogs, I want to start one of my adaption of the Farm Boy engine.
Some time back i got my hands on a set of drawings of the famous Farm Boy engine from Jerry Howell. I liked the design of the engine a lot and also the fact that it can be made from bar stock.
Since I'm all metric I had to redraw the plans. While playing around on the CAD I figured, I might as well make the engine a little bit bigger than original and so I settled for a scale of 32mm to the Inch. This means the engine will be about 30% bigger than original.
The engine specs are:
- Bore: 32mm
- Stroke 44mm
- Compression ratio 4:1
- Displacement 35cc
- Flywheel diam 192mm
Because I've never made a one piece crankshaft before, I decided to start with that one, so in case it is not turning out right I can still abort the project...
To start with I got some normalized S355 bar which will hopefully not distort too much while being machined
The round bar was machined square and then the shape of the crank was roughed out
Then turning the crank pin
Roughing the outer parts of the shaft
Since I've done some wrong thinking
, the crankshaft hat to be shortened and center drilled again
To then finishing the shafts
That's what it looked like so far. I left some material to take a skim cut on the crank webs too.
Moment of truth
I think I can live with a runout of about 0.02mm
So I went on with cutting the keyways
And cutting the key accordingly
Done:
Plani