Author Topic: From Manual to CNC - Sherlines  (Read 19358 times)

Offline ozzie46

  • Full Member
  • ****
  • Posts: 297
Re: From Manual to CNC - Sherlines
« Reply #300 on: September 02, 2021, 10:45:46 PM »
I am so sorry to hear this Zee.
I can only imagine how you feel.

l almost lost my wife in Dec. Praise God didn't.  That was bad enough.

Keeping you and yours in prayer.

Ron

Offline Roger B

  • Global Moderator
  • Full Member
  • *****
  • Posts: 5021
  • Switzerland
Re: From Manual to CNC - Sherlines
« Reply #301 on: September 03, 2021, 08:35:30 PM »
Sad times  :( Remember all the good times, they are important  :)  :)  :)
Best regards

Roger

Offline zeeprogrammer

  • Full Member
  • *****
  • Posts: 6811
  • West Chester, PA, USA
Re: From Manual to CNC - Sherlines
« Reply #302 on: September 03, 2021, 08:54:52 PM »
Thank you all very much. It means a lot to me.
She was a very talented, intelligent, and beautiful woman. I miss her terribly.

Hopefully it won't be long before I get motivated to cut metal.
But the holidays are approaching fast and it's going to be a very rough time without Teresa.
I can't imagine putting up the Christmas tree with all of her homemade ornaments.

Happily, my two daughters live very close to me and I see each at least twice a week.
They've taken well after Teresa with cooking, gardening, writing, hobbies, etc.
They're fine daughters and I'm very proud of them.
They've been extremely helpful to me and I hope I am as well to them.

Both daughters were pregnant during this time. Can you imagine what they went through?
Happily both gave birth just weeks before Teresa's passing and she was able to see them.
I now have two granddaughters from one and two grandsons from the other.

It's good to have friends and a forum that lets one release once in a while.
Thank you.
Carl (aka Zee) Will sometimes respond to 'hey' but never 'hey you'.
"To work. To work."
Zee-Another Thread Trasher.