Help! > Mistakes, muckups, and dangerous behaviour
Not what was intended
(1/1)
Paulc:
Milling a slot in a piece of aluminum held in the vise.
All going well until I see sparks (from aluminum??).
Then noticed I had milled a nice slot in the overly long vise hold down screw.
Oh well,it was too long anyway.
Firebird:
Hi Paul
Been there, done that, got the badge :facepalm2:
Cheers
Rich
steamer:
Paul,
The only ones who never make a mistake are the ones who never do anything...... Keep cranking!
8) :ThumbsUp:
mike mott:
You did see the lovely semicircular kiss I made in my brand new vice a couple of months ago, didn't you? welcome to the club I am also a member.
Mike
Navigation
[0] Message Index
Go to full version