Supporting > My Workshop
Alba 1A Restoration
Joco:
Finally finished the leadscrew nut today. After a test fit I discovered there was no value to be gained by rounding the end over like the original. I suspect that was done on the original casting to save material. It is not needed for clearance.
Pics attached ...
#1 to #4 show the initial machining results.
#5 shows the relief cut into the new nut
#6 installed and ready to have the table assembly begin. I have installed the table slide and tested things. It runs super smooth. Very happy.
Added link to a little video:
https://www.youtube.com/watch?v=tnY9149Abmc
Cheers - J.
Steamer5:
Nice work James!
Cheers Kerrin
Joco:
Finished. A a fully assembled and working shaper. The only thing to complete now is some leveling feet. I'll keep a track of progress and design on those and post here. In the mean time here is my little youtube vid showing the fully functional shaper.
http://www.youtube.com/watch?v=nT1i_2N8lQ8
Admiral_dk:
Great to see it run after all the TLC you have put into it :ThumbsUp:
Now you just need to see it work on a piece of metal :cheers:
Steamer5:
:whoohoo:
Well done James! You have done a grand job
Cheers Kerrin
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version