Help! > Tooling Review

Proxxon FD150/E

<< < (3/3)

Admiral_dk:
So are you still happy with the FD150 ?

Roger B:
Yes I am happy with the price/performance ratio. It is much easier to work with small components when you can get close and see them. I have discussed some of my perceived deficiencies with Proxxon and they have given their views. They are not offering a 4 jaw independent chuck as they are not sure their target group for this machine will understand the balance issues.

Could I make better injectors if I had spent more bought a Sherline or even more and bought a Cowells. I'm not sure  :thinking:  ::)  Being able to clean your lathe before putting it out the way on the shelf by holding it over the waste bin and shaking it has some advantages  ;)

Vixen:

--- Quote from: Roger B on August 23, 2021, 05:07:13 PM ---
  Being able to clean your lathe before putting it out the way on the shelf by holding it over the waste bin and shaking it has some advantages  ;)


--- End quote ---

 :lolb: :lolb: :lolb:  I wish.

crueby:

--- Quote from: Vixen on August 23, 2021, 08:15:11 PM ---
--- Quote from: Roger B on August 23, 2021, 05:07:13 PM ---
  Being able to clean your lathe before putting it out the way on the shelf by holding it over the waste bin and shaking it has some advantages  ;)


--- End quote ---

 :lolb: :lolb: :lolb:  I wish.

--- End quote ---
Sounds like Vixen would need a crane and a dump truck to do that with his lathe!   :Lol:

Navigation

[0] Message Index

[*] Previous page