Welcome to ModelEngineMaker !If you have problems registering or logging in, please use the contact menu option to request assistance.
QuoteI putted a wrong number in tha cnc ;-) Been there - done that ...!.... though not with a bolt circle .... more like a move that broke the tool
I putted a wrong number in tha cnc ;-)
Ditto But mine was the probe off the 3D taster got the wrong axis set on the pendant twirled the wheel ping Shame about the bolt circle just smile and reprogram ,press start and all will be good
I'm looking at the relief around the valve area (red arrow). Is that double facet clearance or is that the valve face itself? Maybe the actual valve seat contact is a much smaller band (green arrow)? I seem to recall the Edwards is a conical combustion chamber, not a hemi, is that right? Maybe that's why it looks more pronounced.
That's a pretty clever solution!Kim
Is that your own mod? Maybe I missed, I didn't see wrist pin pads on the original drawing? What keeps them attached to the ends?My radial is a bit different. Wrist pin ends are slightly drilled & the pads have a little corresponding boss that fits in there. I'm not sure if its supposed to be permanent or no though.