Supporting > Engine Ancillaries

Governor for the Stuart Beam Engine

(1/8) > >>

Jo:
A few years ago I was given a rather sad Stuart beam that had been started as an apprentice piece. I am not sure if it was originally one engine or was a collection of all the bo-bo's from a number of apprentice engines. I fixed it up and it now works but it is only the basic engine. :???:

Looking in my Stuart catalogue I noted that they used to sell a set of castings for a governor, but they do not list them anyone. I like making governors  ;D but my original set of Stuart drawings does not show the  governor. Does anyone know where I could acquire a set of drawings for the governor ;).

Jo

Bluechip:
Jo

If it's the same as for a #9 I got 'em in my paw now.

Big sheet though, and not too good a print.

Dunno if they'll scan.  Copyright anyway ..

Dave BC

EDIT sez DWG 90001 on the top.

steamer:
Same boat Jo....I think I have the book on the 9.   

Dave

Jo:
I have just checked the catalogue: The governor on the 9 has a different part number than the beam's governor.

Jo

Bluechip:

--- Quote from: Jo on October 14, 2012, 06:02:45 PM ---I have just checked the catalogue: The governor on the 9 has a different part number than the beam's governor.

Jo

--- End quote ---

Ah well, such is life.  :'(

Shame really, scanned at 200dpi greyscale, they're more readable than the original ..

BC

Navigation

[0] Message Index

[#] Next page