Welcome to ModelEngineMaker !If you have problems registering or logging in, please use the contact menu option to request assistance.
Another batch of nice new shiny parts Great that you caught the missing clearance before commiting to making the rest of the camlobes
Hello Achim,Looking good Keep a close eye on those roller pins when the engine is run. There is not much Loctite holding them in place and rockers always experience a lot of hammering.Mike
Hi Mike, thanks for your advise.I have had already mixed feelings when I assembled it.In Dougs drawing is no special advise for this fit. His has designed the holes with 0.0938" and the pins also, that´s it.
Quote from: fumopuc on May 27, 2021, 01:25:58 PMHi Mike, thanks for your advise.I have had already mixed feelings when I assembled it.In Dougs drawing is no special advise for this fit. His has designed the holes with 0.0938" and the pins also, that´s it.Hello AchimCould you make some different pins, with a small flange at one end and drill and tap the other end M 1.5 ?Or drill and tap M 1.5 both ends?Mike
Hi Achim, the detail in your model just keeps getting better and better. Your skill and methodical approach shows in every post.MJM460
If you decide to use a small dab of Loctite, put a small drop of it in one side of the rocker arm then insert the roller pin in the rocker arm from the opposite side of the rocker arm. Then oil the roller.Jeff
I assume that is intentional so the valves close quickly and follow the shape of the cams?Kim