Help! > Tooling Review

Keats Angle Plate

<< < (3/6) > >>

tel:
The other option is to fabricate one - it was Len Mason (I think) who gave a good description of doing this in one of his books.

I have a little micro version here that I made to go on the 3" faceplate I made.

IanR:

--- Quote from: tel on September 02, 2012, 10:03:14 PM ---The other option is to fabricate one - it was Len Mason (I think) who gave a good description of doing this in one of his books.



--- End quote ---
It was, in "Using The Small Lathe", published in 1963.
The gadget in the original post is not a Keats. This is a Keats.

steamer:
Thanks for that Ian!

Dave

sshire:
This appeared in the mail today.



I ordered it 3 days ago with standard shipping. I don't get stuff that fast from McMaster and they are just 80 miles from here (Philadelphia, PA)

Drilling of faceplate will commence as soon as I finish the Epicyclic Engine flywheel.

Best
Stan

Don1966:
Stan you guy made me break down and order one, and by the way how is the Epicyclic engine coming alone. Are you doing a built log?

Don

Navigation

[0] Message Index

[#] Next page

[*] Previous page