Supporting > Additive Machining

3D printer questions

<< < (8/8)

wagnmkr:
The printer is working well and most of the prints are good.

I tried this cylinder yesterday and got a poor result. I had told the slicer to build a support wherever it would touch the buildplate and got this terrible result.

Notice that the surface of the main cylinder is the same as the surface on the bottom of the valve chamber where it printed support material. I will print this again, but without the support. I just have to wait until tomorrow when my new stock arrives.

Tom

Navigation

[0] Message Index

[*] Previous page

Go to full version