Author Topic: lever collet closer on an 11" Sheldon Lathe  (Read 1564 times)

Offline jeff l

  • Full Member
  • ****
  • Posts: 234
lever collet closer on an 11" Sheldon Lathe
« on: June 17, 2015, 01:34:30 PM »
I have an 11" Sheldon Lathe and I would like to install a lever collet closer , but I can't seem to find a suitable place to attach the pivot .I think the gear cover is too light and would crack after a while .Has anyone  here ran into a similar problem , thanks .Jeff

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal