Help! > Tooling Review

Small hex key set

<< < (2/3) > >>

Roger B:
I use the 0.89mm (M2 grubscrew) a lot but haven't used the 0.71mm yet.

Robert Hornby:
Sorry to hijack this thread, but on a similar theme I have been looking out for very small spanners/sockets for BA nuts. Any ideas out there?

Steam Haulage:
No need to buy exotic imported 'Allen' keys or Spanners.

King Dick are still going strong and in the UK, go to their site and find a distributor. Quality as your grandad would remember it.

I use Abbots Tools, friendly helpful if you ring them, but I normally use their website, prompt delivery. Only connection: I used to to work in a factory next to K-D in Birmingham. :ThumbsUp:

Jo:
I make all my small BA nut spinners out of Allen screws.

Commercial spanners normally only go down to 10BA  :-\.

Jo

sshire:
Over here, in the Colonies, Moody Tools makes beautiful, small "spanners" and other small tools. Wouldn't be without mine.

http://www.moodytools.com/MTI_CATALOG_PAGE_20.pdf

Navigation

[0] Message Index

[#] Next page

[*] Previous page