Engines > Your Own Design
Potty Dake Engine
sbwhart:
I've had an ankering to build a Dake engine for quite some time, when I came across informations on Pat's fathers Dake engine, since then I've researched the engine quite a few times each time I've advanced my understanding and spent a long time thinking about the best way to machine one from bar stock.
Over the last week I've been putting together an assembly drawing I've simplified things quite a bit to suite my methods and machinery. I'm not quite sure when I'll start to cut metal probably in a couple of months when I make more progress on my Simplex loco rebuild.
I've attached the assembly drawing:- comments will be apreciated.
Stew
Bearcar1:
Oh man, I got the popcorn going and a chair pulled up for this one. I can't wait to see how it develops after your last beautiful S/S build, Stew. :ThumbsUp:
BC1
Jim
sbwhart:
Thanks Jim
I think there are quite a few popcorns out their :ThumbsUp:
Stew
sbwhart:
Air passage routes sketch attached
vcutajar:
Stew
Will be following this one for sure. I hope Jim brought some extra popcorn.
Vince
Navigation
[0] Message Index
[#] Next page
Go to full version