Supporting > Vehicles & Models
Class 4 tank
Stuart:
Here are a few random shots I have some earlier one but cannot get them off the server yet
cylinder and part motion
more of the motion
reversing gear box this is a fully working gearbox, and drivers pedestal
up front
Stuart:
safety valve
this is one of the pair the small holes or number 80 36 in a ring the second ring is offset by 5 deg again number 80 drill the bolts at the top are no. 12 ba the ones at the bottom are just dummies as these screw in no bolted as per full size
these are mild pop valves
if any on wants a peep inside let me know and I will post a stripped down view
Stuart
Dan Rowe:
--- Quote from: Lordedmond on July 22, 2012, 03:53:30 PM ---if any on wants a peep inside let me know and I will post a stripped down view
--- End quote ---
Stuart,
Of course we want to see what is inside. Picture a guy jumping up and down with a sign that says WE Want Pictures.
Very nice work is it 1" to the foot scale?
Dan
Stuart:
Dan
I will get the valve stripped down tomorrow and get the canon 7d and 17 -40 L out then
it is infact 1 and 1/16 to the foot that give 5 inch gauge true scale if it was 1 inch to the foot the full size would have a 5 foot gauge not 4 foot 8 1/2 inches
its just me and the heap of plans that dictate the sizes
where we have to deviate is the boiler fixings bolt on would not be robust enough
Stuart
Dan Rowe:
Stuart,
I often wondered about the scale for 5" gauge. I see that I am not the only guy building to a unhandy fraction.
Dan
Navigation
[0] Message Index
[#] Next page
Go to full version