Help! > Hints, Tips & Tricks

pantograph scaling

(1/2) > >>

tghs:
 a miniature maker I follow needed to make some scale (1/8th) drawer-front brass plates, he made a full sized template and set an old pantograph machine fitted with a small bit/cutter/engraver to the scale required and great looking parts were produced,, Yes I have access to one of these old beast, thinking now I have something else to try,,   maybe hinges, engine labels.. I could also see this might work just to mark lines before sawing out the part.. :cheers:

crueby:
I have an old New Hermes pantograph type engraving machine, works great for nameplates, but I  never thought to use it for other parts. Are you thinking of using it to cut outlines of parts through a plate?   :thinking:

tghs:
I'm thinking it would be a good line marking method if you have repetive parts,, instead of trying to mark the lines by hand or gluing on a paper pattern..

pgp001:
The pantograph engraver is a very useful tool especially one that can do three dimensional shapes, I have a very old David Dowling one that can do this.
I made the motion cover emblems for my 3" scale Ruston Proctor Steam Tractor with mine, I borrowed the original ones of the full size engine to use as a master for copying at ¼ scale.






Phil P

crueby:
Thats really clever - didn't know they made ones like that. Very different base than the usual engraving version like I have. I've seen big duplicating setups for routers used to make multiples of wooden parts like carousel horse blanks (very old machine too).

Great parts!

Navigation

[0] Message Index

[#] Next page