Supporting > Tooling & Machines

HV-6 rotary table - dividing plates

(1/2) > >>

redhouseluv:
I went to fix my new dividing plates to my rotary table which looked relatively simple, remove handle and fix plate using 3 hex bolts and to my surprise and disappointment there are no holes! Look at last image from a video - that's what I was hoping to see
 
I took the locking ring off as well, but there's no way of holding these plates - has anyone comes across this before or are there some other types of dividing plates? OR am I being a bit dumb? Not too keen to be drilling holes into the inner locking ring but...........

I'm sure where I bought them from will allow me to return them as they are unopened, but that doesn't resolve the problem!

uuu:
In order to get the holes correctly spaced you'll need to mount the relevant component onto some kind of flat device that can be rotated with precision.

Wilf

redhouseluv:
If had to drill it I have a smaller rotary table I could use to rotate it, however, given the issue so far I would need to check the plate centre and spindle are the correct diameter otherwise its a non-starter.

Google tells me:

PCD: 32mm
Inside diameter: 21mm
Outside diameter: 100mm
Thickness: 7mm

Hmmm......

Jasonb:
You could spot them through, mine has quite generous clearance size holes and the screws are not exactly high quality.

redhouseluv:
Thanks, I was thinking that, let me check the spigot on the table is the correct size for the plates.

Navigation

[0] Message Index

[#] Next page