Help! > Hints, Tips & Tricks
A shout out to Quinn about odd reamers
steamer:
--- Quote from: Kim on December 15, 2024, 10:51:53 PM ---I used a 4.2mm reamer for that. 4.2mm= 0.1653". A 4.2mm reamer was readily available for not too much cash. I'm betting that's what Kozo used. He had several reamed holes in the drive and valve linkage that were listed in mm, like 9mm and 10mm. Those were specifically called out though. As Quinn mentioned, this was clearly a metric design he'd converted to inch measurements for US consumption!
Kim
--- End quote ---
Still $27 vs $3 and some labor....
Kim:
--- Quote from: steamer on December 16, 2024, 01:41:54 PM ---
--- Quote from: Kim on December 15, 2024, 10:51:53 PM ---I used a 4.2mm reamer for that. 4.2mm= 0.1653". A 4.2mm reamer was readily available for not too much cash. I'm betting that's what Kozo used. He had several reamed holes in the drive and valve linkage that were listed in mm, like 9mm and 10mm. Those were specifically called out though. As Quinn mentioned, this was clearly a metric design he'd converted to inch measurements for US consumption!
Kim
--- End quote ---
Still $27 vs $3 and some labor....
--- End quote ---
Very true, Dave! Making it yourself is a much less expensive option! ;D
Kim
Navigation
[0] Message Index
[*] Previous page
Go to full version