Supporting > My Workshop

Cincinnati Toolmaster

(1/2) > >>

propforward:
Mostly I'm just testing a photo hosting site - but to do it here are a few pictures of a knee mill I acquired earlier this year. Grubby but mostly in good order (and it was cheap). I'm currently making repairs to the belt drive and going overboard with those, but it should be back online soon.

As acquired.






Cleaned and in place.



Head apart for maintenance.



Making a new pulley sheave from a block of onhandium. Actually Alca 5 cast tool plate - it was half the price of an appropriate piece of round bar / rod.

propforward:
Seems to work OK.

MJM460:
Hi Stuart, a nice acquisition.  It has cleaned up nicely.

MJM460

Kim:
Seems like your photo hosting site test worked great!

And nice new-to-you mill!     :ThumbsUp: :popcorn:

Kim

propforward:
Thanks Gents.

I’m trying the image site crueby uses. Seems pretty decent - easier to use than onedrive personal. MJM has encouraged me to post a log of my next engine, which I will start after work on the mill belt drive is finished - not too far off now.

Navigation

[0] Message Index

[#] Next page