Engines > From Kits/Castings

My Pm Research # 1 Mill Engine

(1/1)

pirmin:
Hey Guys,

i made the No. 1 Mill Engine about 1 year ago and never made a Base for it, i also run out of patience to cut down all the studs to final lenghs, so now i want to show the final result to all of you! all studs shortend, Base stained in oak colors :)

i might make a few more alterations on the base, maybe add some fence posts , a scale tile floor and will mount a exhaust flange in the future .


but for now i am happy with it, the way it is !


Cheers Pirmin

Admiral_dk:
Looks good  :ThumbsUp:

And don't forget that the most important fact is a happy builder  ;)

Per       :cheers:

samc88:
Looks great, studs and nuts look much nicer than the screws that usually come with PM models

pirmin:
yes, also the oilers in the PM Drawings are pretty much off if u want a scle looking model. i also made no use of the bronze crosshead guides, i made some of cast iron and polished the tops. i then used Easylap ultrafine for the break in procedure, the negines runs superb smooth on live steam, no leakages

Navigation

[0] Message Index