Supporting > Additive Machining

Large Skeleton Clock

(1/3) > >>

wagnmkr:
It has been a while since I posted anything here so here goes....

I find a box in the basement a couple of days ago and had no idea what was in it. Imagine my surprise when I found the bits and pieces of a printed clock. Once I saw what it was I remembered printing it  but I have no idea why I put it away without assembly.

Anyway there were only 2 parts that I hadn't printed so I got those going and put the thing together. The first run was not successful so I took it apart, did a couple of tests, and found that the bearings hadn't been degreased as good as they could be. An overnight soak in some degreaser, assembly again this morning, and when I hung it on the wall, away it went.

This was made from odds and sods of filament so it is quite multi coloured. I might do this one again, only in a better colour scheme.


http://www.youtube.com/watch?v=ZT84kPoE9vo

Kim:
That's a very nice clock!  I may have to make me one of those someday...  :ThumbsUp: :popcorn:

Kim

wagnmkr:
Hi Kim,

Yes, you will soon have time on your hands!

I'll go to my room now :cheers:

mklotz:

--- Quote from: wagnmkr on August 28, 2024, 04:12:06 PM ---Hi Kim,

Yes, you will soon have time on your hands!

I'll go to my room now :cheers:

--- End quote ---

Take CNR6400 with you when you go.  Have someone lock the door from the outside.

paul gough:
What a delightful re-discovery from the basement. Looks a very attractive piece of mechanical animation for a blank spot of wall. Regards, Paul Gough.

Navigation

[0] Message Index

[#] Next page