Help! > Hints, Tips & Tricks

Creating a Step-off Chart for Turning Radii

<< < (5/5)

crueby:
Thats a ringing endorsement for the step off chart method George!  :ThumbsUp:

When doing curves like that on the mill, do you use an end mill with a rounded corner to help blend the steps?

gbritnell:
All ball end mills down to 3/32 diameter.

crueby:

--- Quote from: gbritnell on May 29, 2024, 12:36:14 AM ---All ball end mills down to 3/32 diameter.

--- End quote ---
Good to know - thanks!

Navigation

[0] Message Index

[*] Previous page