Vince's version of the MEM Corliss

[vcutajar]

If you do not see the photos in this build log I suggest you look here:
https://modelengineeringwebsite.com/Corliss_engine_build.html

Vince

[vcutajar]

Hi
Recently I got myself a new laptop and after installing Fusion (formerly Fusion 360) it started complaining that the graphics card is not compatible.  I have an Intel UHD GPU and 16Gb of on board RAM.  I cleared the warning and never gave that warning again.  But it was always at the back of my mind whether Fusion will work or not on a large project.

So decided to make a 3D model of the MEM Corliss and animate it.

Happy to say that Fusion worked like a charm on my new laptop.

<a href="https://www.youtube.com/watch?v=y9hwJvgTezU" target="_blank">http://www.youtube.com/watch?v=y9hwJvgTezU</a>

<a href="https://www.youtube.com/watch?v=ASZdADZhpmI" target="_blank">http://www.youtube.com/watch?v=ASZdADZhpmI</a>

Regards

Vince

[fumopuc]

Hi Vince,
good to see that you enjoy the virtual model engineering also.
For me it was a great fun to learn and use it.

[crueby]

Great design and animation!   I've been  using Fusion for years, it will do quite large assemblues as long as you have enough memory on your computer, my biggest was the entire Marion 91 steam shovel. They do depend a lot on the graphics card, but there are some settings to reduce that.


 

[Admiral_dk]

Great animation Vince        

Per       

[vcutajar]

Thanks Achim, Chris and Admiral.

Vince