Engines > From Kits/Castings

Anderson/Ericksson hot air engine

(1/2) > >>

Tom Jamboretz:
     I have recently procured a engine kit. I have not found any information on the engine full sized or model. The plans are not to specific or complete. If any one knows of the engine I would appreciate any help that you could give.  TJ

Jasonb:
Can you post some pictures, it is not one that springs to mind but knowing the type would help.

Also is that the spelling or should it be Ericsson

Jasonb:
Does it look like this?

https://patents.google.com/patent/US646406A/en

http://www.youtube.com/watch?v=-Usiqpow_s0

Dave Otto:
I have a casting kit that was produced by the late Paul Jacobs, I purchased mine from Paul long ago. As far as I know I have a complete set of drawings, so I might be able to help you out with the missing drawings if you have the same kit.
Yes pictures would be helpful.

Dave

Jasonb:
Dave, is it of the same subject as my link or did Anderson, Erickson do other engines at some time in the past? Would make a good subject to scratch build as the displacer on the top is quite an unusual layout.

Navigation

[0] Message Index

[#] Next page