Supporting > Boilers
A WATERTUBE BOILER FOR MY TRIPLE EXPANSION ENGINE
Laurentic:
John - thanks for the heads up on the tube
Chris :ThumbsUp:
crueby:
What type of torch is it - oxy/acetylene, propane, other? Also, was looking at the tubing you showed in that link that you were using, the walls seem awfully thin?
Vixen:
--- Quote from: crueby on February 16, 2024, 07:55:51 PM ---What type of torch is it - oxy/acetylene, propane, other? Also, was looking at the tubing you showed in that link that you were using, the walls seem awfully thin?
--- End quote ---
Did you use thin wall hydraulic brake pipe or thicker wall steam boiler pipe?
Silver solder melts at around cherry red temperature, Copper melts at bright orange temperature. A darkened room will help you see the colour of the metal. you may need to move the torch away, for a moment, to see the metal colour, hence temperature.
Mike
simplyloco:
Guilty as charged Your Honour! I used a big propane burner on thin brake pipe even though it takes high pressure. I seek clemency and I promise not to do it again... :old:
crueby:
On parole for now! :ROFL:
The reason I asked about the torch type is that some fuels burn a lot hotter than others. Even a propane torch can easily hit 1200C or higher, well above copper melt temps. I've had cases where I overdid things and had copper and brass parts soften and sag. Even steel parts can soften enough to sag under their own weight. Watching the color/glow of the metal is very important, as was said by others doing this work in dimmer light makes it a lot easier to see where the metal is starting to glow.
For the piping like that in boilers, better to use the thicker walled stuff anyway. The times I've used smaller diameter tubing it was much thicker walled, which made it heat up more like the larger boiler shell, still had to aim the flame more at the larger shell and let it heat the smaller tube rather than direct flame on the smaller tube. Silver soldering thin parts, or thin parts to thicker parts, is definitely tricky, must put the flame more on the thicker/heavier parts to even out where the heat flows.
Hope you can get it reworked or remade, it was going so well!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version