Engines > From Plans

large vacuum engine

<< < (2/17) > >>

crueby:
Looks like a fun build - following along here!
 :popcorn: :popcorn: :popcorn:

Michael S.:
The last casting part is the holder for the cylinder.
There is already a hole of 50.00 mm but I need 60.00 mm.
The milling machine was used to drill out and all the other holes were made straight away.
All other work must be done without castings. I will now prime the castings with paint and then paint them red. That's fitting for a flame eater.

Michael


http://www.youtube.com/watch?v=F8ikEPygi-A

crueby:
Great start on the parts. Those flywheels are perfect for this engine.    :popcorn:

Kim:
That's a pretty good sized engine, Michael!  Looking forward to watching you work on this one  :popcorn: :ThumbsUp:

Kim

cnr6400:
 :ThumbsUp: :ThumbsUp: :ThumbsUp: :popcorn: :popcorn: :popcorn:

Navigation

[0] Message Index

[#] Next page

[*] Previous page