Supporting > Additive Machining

Pendulum Clock

<< < (17/17)

wagnmkr:
 :slap: :slap: Why didn't I think of that! A mark on the wall ... Whoda Thunk It! I will do that right away and that problem should be gone.

Krypto, I am still dialing it in, but it is right in that ballpark of a minute a week. My wife made the comment this morning that it is the most accurate clock in the house, other than the computer / internet controlled ones.

Time for the next one!

 :cheers:

crueby:

--- Quote from: gerritv on February 25, 2024, 04:20:28 PM ---And when you move out of the house, the next owner is left wondering what that little mark is about :-)
All of my wall mounted clocks have that mark,

gerrit

--- End quote ---
My cuckoo clock has a mark on the wall next to the bottom corner - when I wind it I have to line up the case to the mark to get it level again, or it runs fast or slow that week. Easier than getting out a level every time.

wagnmkr:
Thanks for the input. The clock has been going for 24 hours since the last winding so I will put a mark by one of the feet.

I have to say I am impressed with how well this clock runs and I am looking forward to doing another one.

 :cheers:

Navigation

[0] Message Index

[*] Previous page