Author Topic: My 2 PM Research Engines  (Read 1389 times)

Offline rustychip

  • Full Member
  • ****
  • Posts: 10
My 2 PM Research Engines
« on: May 15, 2023, 01:35:37 AM »
I had made some bar stock engines before but never one from castings, the smaller no.1 was a lot of fun to make, the bigger no.4 was fun but to big for my little lathe and mill so I did flywheel and base at work (full size Bridgeport and very large Summit lathe.
« Last Edit: May 15, 2023, 01:39:48 AM by rustychip »

Offline crueby

  • Full Member
  • *****
  • Posts: 20239
  • Rochester NY
Re: My 2 PM Research Engines
« Reply #1 on: May 15, 2023, 02:16:55 AM »
Excellent  engines!   

Offline EricB

  • Full Member
  • ****
  • Posts: 165
Re: My 2 PM Research Engines
« Reply #2 on: May 15, 2023, 04:06:59 AM »
Beautiful!

Offline Kim

  • Global Moderator
  • Full Member
  • *****
  • Posts: 8611
  • Portland, Oregon, USA
Re: My 2 PM Research Engines
« Reply #3 on: May 15, 2023, 06:26:58 AM »
Very nice!  Lovely engines you have made there   :ThumbsUp: :popcorn:

Kim

Offline Chipswitheverything

  • Full Member
  • ****
  • Posts: 622
Re: My 2 PM Research Engines
« Reply #4 on: May 15, 2023, 09:01:29 AM »
Very handsome model engines, thanks for posting.  Hope that you will want to get back to finishing the lovely radial petrol engine, so much is already done!  Dave

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal