Author Topic: My Demon V8 build  (Read 135633 times)

Offline Doc

  • Full Member
  • ****
  • Posts: 855
  • USA ND
Re: My Demon V8 build
« Reply #555 on: September 29, 2017, 02:12:27 AM »
Thanks Don!


Offline Ye-Ole Steam Dude

  • Full Member
  • ****
  • Posts: 1564
  • Deep East Texas on Sam Rayburn Lake
Re: My Demon V8 build
« Reply #556 on: October 06, 2017, 09:38:10 AM »
Outstanding work Doc, sure do enjoy following your builds.

Thomas

Offline ozzie46

  • Full Member
  • ****
  • Posts: 289
Re: My Demon V8 build
« Reply #557 on: April 17, 2021, 07:51:17 PM »
Doc,  if I may impose on you, on the Demon V-8 exhaust system, not the zoomies but the one with the collector box, what dia. bending block did you make for the tubing bender you made to make the bends.?
 Thanks in advance
Ron
aka ozzie46

Offline Doc

  • Full Member
  • ****
  • Posts: 855
  • USA ND
Re: My Demon V8 build
« Reply #558 on: April 18, 2021, 04:00:26 PM »
I'll check the size as I don't remember. I do know I struggled with deforming the tube I ended up packing them with corn meal before forming them. I'll check the size when I'm get out in the shop.

Offline ozzie46

  • Full Member
  • ****
  • Posts: 289
Re: My Demon V8 build
« Reply #559 on: April 18, 2021, 08:32:38 PM »
Ok, thanks
Ron

Offline Doc

  • Full Member
  • ****
  • Posts: 855
  • USA ND
Re: My Demon V8 build
« Reply #560 on: April 19, 2021, 04:48:50 AM »
The tightest tube bend looks to be .50 radius. I looked for my mandrels but was unable to find where I put them. That was the header tubes for the zoomi tubes it was tighter bends.

Offline ozzie46

  • Full Member
  • ****
  • Posts: 289
Re: My Demon V8 build
« Reply #561 on: April 19, 2021, 01:07:53 PM »
Thanks a lot Doc

ozzie46