Author Topic: Cast from 3d model  (Read 297 times)

Offline BillTodd

  • Full Member
  • ****
  • Posts: 491
  • Colchester UK (where the lathes were made)
    • Bill's website
Cast from 3d model
« on: September 29, 2022, 05:07:41 PM »
I was tasked to make a couple of Bentley lock escutcheons for a friend.

Modelled and rest printed on mt elegoo Saturn, then sent the file to india for casting 

I'm very pleaed with the results  , had to spend some time finishing and polishing.

Offline bent

  • Full Member
  • ****
  • Posts: 718
  • Wet side of Washington State, USA
Re: Cast from 3d model
« Reply #1 on: September 29, 2022, 06:00:54 PM »
So the chrome piece is original, and the bronze/brass pieces are the castings it appears?  They look pretty nice as cast, should clean up and chrome plate quite nicely, congrats!  :cheers:

Offline A7er

  • Full Member
  • ****
  • Posts: 197
Re: Cast from 3d model
« Reply #2 on: September 29, 2022, 06:23:46 PM »
Very impressive!