Infinity Cube

[bent]

If one had a tube bender and an orbital welder...

[EricB]

OK now the next step is a bit more complex . :-)   Here is one someone showed me some time ago and the wooden one I did in the woodshop to check it out.  the wood joints are doweled.
   ...Lew...

This would be an interesting puzzle to machine in one piece. I might just give it a try.

Eric

[Robert Hornby]

Hi again all. I have been offline for quite a while and now I wish to have a go at the infinity cube in wood with mitered joints. I could draw it all up but I am being lazy and requesting if there are any drawings available. I would be forever grateful.
Bob

[cnr6400]

Good to see you again Bob! 

[Robert Hornby]

Thanks cnr6400, I have been away from the workshop for a while but now keen to get on with something other than an engine. So still looking for plans for the the Infinity Cube.

[Kim]

I just did a Google search for "Infinity Cube Plans" and came up with a bunch of hits.  Here's one:
https://grabcad.com/library/infinity-cube-infinity-cube-square-hollow-20x20-1

Don't know that it's the best one, but there seemed to be a lot of options out there.

Kim

[Alston]

OK now the next step is a bit more complex . :-)   Here is one someone showed me some time ago and the wooden one I did in the woodshop to check it out.  the wood joints are doweled.
   ...Lew...

This would be an interesting puzzle to machine in one piece. I might just give it a try.

Eric

I was wondering this but I’m not sure it can be milled from one piece?
It could be done from three pieces though I think. Even bolted together with cap head socket screws it would still be a good conversation piece. I’ll have to give it some thought, a 2 - 3” cube would be good.