Author Topic: Vulcan Beam Engine made @ 80% progress so far  (Read 1034 times)

Offline geoff5269

  • Full Member
  • ****
  • Posts: 152
Vulcan Beam Engine made @ 80% progress so far
« on: March 17, 2022, 08:53:16 PM »
I am slowly working thew this project I decided to do it because there are shapes I haven't done before such as the A frames and the girders that wrap around to hold the parallel motion. First i have to convert to metric and then to 80% and redraw it. I scratch built the A frames and the Beam and cylinder with Pedestal O.K but it is the girders that are proving tricky were they screw to the A frame as there is no room to get a spanner in, I could use a slotted screw but it doesn't feel right. Any way I just thought i would show work so far.
Geoff

Offline pgp001

  • Full Member
  • ****
  • Posts: 812
  • West Yorkshire - UK
Re: Vulcan Beam Engine made @ 80% progress so far
« Reply #1 on: March 17, 2022, 11:11:30 PM »
Those bits are looking very nice  :ThumbsUp:

Phil

Offline crueby

  • Full Member
  • *****
  • Posts: 18557
  • Rochester NY
Re: Vulcan Beam Engine made @ 80% progress so far
« Reply #2 on: March 18, 2022, 12:39:50 AM »
Beautiful parts!

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal