Engines > From Kits/Castings
Stuart No1 centrifugal pump
Steamingandy:
I started a set of castings for the No1 centrifugal pump not available now, I’ve decided to put flanges on the inlet and outlet to give a bit more character and use O rings for seals
crueby:
Interesting pump - what is the diameter of the main body?
:popcorn:
Steamingandy:
--- Quote from: crueby on November 25, 2021, 11:05:20 PM ---Interesting pump - what is the diameter of the main body?
:popcorn:
--- End quote ---
The No1 is 3”
Jasonb:
Off to a good start.
There is quite a bit of info about the Stuart pumps on this site for those interested.
http://stuartturnersteam.com/Machines/waterpmp/waterpmp.html
Steamingandy:
Next bit impeller veins have a 6deg run to the outside
Navigation
[0] Message Index
[#] Next page
Go to full version