Author Topic: Adept No 2 Hand Shaping machine  (Read 1158 times)

Offline Trevorc

  • Full Member
  • ****
  • Posts: 134
Adept No 2 Hand Shaping machine
« on: November 05, 2021, 03:19:08 PM »
Hello , many years ago at the Clubs “ bring and buy” I purchased an Adept No 2 Hand Shaping machine- the price I paid reflected the fact that it was short of the front table onto which the workpiece , or machine vice, would have been clamped.
I have tried to find a table to complete the machine but no such luck so the only option is to try to fabricate one. I would like it to be an accurate replacement but I do not have any dimensions.
Does any member of this forum own the No 2 machine who would be prepared to give me the critical dimensions as well as a few photos. Many thanks if you can.

Regards
Trevorc

Online Jo

  • Administrator
  • Full Member
  • *****
  • Posts: 15294
  • Hampshire, england.
Re: Adept No 2 Hand Shaping machine
« Reply #1 on: November 05, 2021, 03:24:31 PM »
That's the big one  ::) Mine is the little one.

There are some good pics of big brother on here: http://www.small-lathes.co.uk/Adept-No.-2-Hand-Shaper-[A2HS]/1010.htm (you need to copy the link and past it into your browser to work )

Jo
« Last Edit: November 05, 2021, 04:23:40 PM by Jo »
Enjoyment is more important than achievement.

Offline Trevorc

  • Full Member
  • ****
  • Posts: 134
Re: Adept No 2 Hand Shaping machine
« Reply #2 on: November 05, 2021, 06:57:13 PM »
Thank you Jo, I have that information already. Unfortunately it does not give any dimensions for the table.
If no one else can help me then I suppose I will have to try scaling the photo.
Regards
Trevorc

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal