Engines > From Kits/Castings
Murdoch-Aitken "Steeple" engine
Jo:
--- Quote from: scc on September 30, 2021, 08:06:56 PM ---This is very new teritory for me.....small and fiddly, The drawing even shows some 14ba bolts :o
--- End quote ---
:headscratch: I found a few 12BA but not 14's. If you don't like 14BA then 1mm might be easier to come by.
I keep wanting to make my one of these ... you have got me tempted :thinking:.
Jo
AVTUR:
Terry
How large is this engine? The diameter of the flywheel would be useful.
I will follow, every so often, with interest.
AVTUR
scc:
Jo, it would be good if you made one.......I could follow along and see how it's done :Lol: None of my usual suppliers even list 14ba, 12 being their usual limit.
Avtur, welcome along, I think the flywheel is about 9 1/2 inches dia. Terry
scc:
OH DEAR, I have just noticed that I spelt the title completely incorrectly :embarassed: :embarassed: It should read "MURDOCH"
Apologies Terry
Jo:
--- Quote from: scc on October 08, 2021, 09:01:49 PM ---OH DEAR, I have just noticed that I spelt the title completely incorrectly :embarassed: :embarassed: It should read "MURDOCH"
--- End quote ---
All sorted ;)
Jo
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version