Engines > From Kits/Castings

Murdoch-Aitken "Steeple" engine

<< < (30/32) > >>

scc:
No,  I have not gone away!!    just been busy.      I have replaced several parts and not kept close to the drawings. Basically the space has been measured and then the component made to suit.   Individual "fitting" is a method that I like.  The end result is a running engine but miles off being  as elegant as others, especially Jo's.
Because of the intermittent build this year no photos :facepalm2: but I did take a little video.    In case I am unable to load it it's on utube shorts....."Table engine running on air"

best Wishes to All.     Terry

Jo:
Well done  :cartwheel:

http://www.youtube.com/watch?v=ZUiDGgKoVKM

I am interested to see some photos especially what you did with the valve shaft as the motion comes off the table and heads down to the crankshaft.

Jo

Jasonb:
Looks good and runs well Terry.

Dave Otto:
Looks great!

Dave

Admiral_dk:
Great runner and good looking  :ThumbsUp: - whats not to like ?

Per        :cheers:

Navigation

[0] Message Index

[#] Next page

[*] Previous page