Author Topic: Did I realy do that?  (Read 2729 times)

Offline Jo

  • Administrator
  • Full Member
  • *****
  • Posts: 14266
  • Hampshire, england.
Re: Did I realy do that?
« Reply #30 on: September 06, 2021, 06:34:36 PM »
That was a  :censored:

If such horrors happen I use a piece of Sellotape over the top and when it is almost dry use a razor blade to trim it level with the bed  ;)

Jo
Enjoyment is more important than achievement.

Offline Vixen

  • Full Member
  • ****
  • Posts: 2260
  • Hampshire UK
Re: Did I realy do that?
« Reply #31 on: September 06, 2021, 06:48:19 PM »
Thanks Jo,

Sellotape and a heavy weight attached as per your instructions.  :embarassed:

I will have to use a brand new Stanley knife (box cutter) blade as my three blade Gillette razor blades wont 'cut it', as they say.

Mike
It is the journey that matters, not the destination

Oh! sod the journey, lets hit the bar and pool instead.

Offline RReid

  • Full Member
  • ****
  • Posts: 347
  • Northern California
Re: Did I realy do that?
« Reply #32 on: September 07, 2021, 01:52:40 AM »
The downside to teaching yourself G-codes on a brand new, $30K CNC Bridgeport is the 1/4 inch hole neatly, if noisily, drilled into the the shiny new table. And having to re-tram the head after calming down (at least it was bought with someone else's money).
Regards,
Ron

Offline Craig DeShong

  • Full Member
  • ****
  • Posts: 1024
  • Raleigh, NC. USA
Re: Did I realy do that?
« Reply #33 on: September 07, 2021, 03:53:20 AM »
As the title says: Did I realy do that?      :lolb: :lolb:



Then, did I realy try to drill a hole with it?

Concentrate lad          :hammerbash: :hammerbash:

Mike

Heck, Id just write this off as not being able to see that well anymore.
Craig
It's not about the destination, not even so much about the journey,
but rather it's the interesting folks you meet along the way.